Hawk
Well-Known Member
What is the best way to sight in?
The elevation adjustment is maxed out and needs to be lower. Any solutions?
The elevation adjustment is maxed out and needs to be lower. Any solutions?
Burris Speed Bead 3 Adjustment
- Thread starter Hawk
- Start date
Setterman
Well-Known Member
Use one of the shims that came with it to raise the entire sight. That should help I believe
another option is get a small piece of felt or tape to put under the front of the mount where it contacts the receiver that will lift it pretty high then you have room to come back down.
- Joined
- Aug 1, 2011
- Messages
- 764
Hawk, I had the same issue with the Burris Fastfire 3. I had to order a shim for it. I ordered 2 shims by accident. I'm not familiar with the speed bead, but if this shim will work for your then you are more than welcome to it! Text me your address and I'll mail it to ya. 901-356-2670.
-Daniel Golden
-Daniel Golden
Attachments
Hawk
Well-Known Member
Thanks for your generous offer but I
Have already ordered some
Sent from my iPhone using Tapatalk
Have already ordered some
Sent from my iPhone using Tapatalk
whiskey
Well-Known Member
Another option is the take the riser and sand it at an angle.
Sent from my iPhone using Tapatalk Pro
Sent from my iPhone using Tapatalk Pro
whiskey
Well-Known Member
You can sand the thin shim, but be careful. I had to drill up into the nubs to get the thin to work. It was fine for the season, but I did end up breaking one when taking the Fastfire off for a new battery.
Sent from my iPhone using Tapatalk Pro
Sent from my iPhone using Tapatalk Pro
