Was using the Rhino to pull some vines and limbs out of a tree and had it in low range,popped out of gear and now just grinds when I try and run it in low,what causes this? It still runs in High and reverse normally.
Rhino wont shift into low
- Thread starter dmonty
- Start date
Adjust the linkage
There are free service manuals here if you scroll to the bottom that should walk you through it:
http://www.501parts.com/downloads/
There are free service manuals here if you scroll to the bottom that should walk you through it:
http://www.501parts.com/downloads/
Thank you !!
