Reloader 23

[lungpuncher1]

Anyone know much about rl23, it's relatively new? I've read rl23 is a better rl22. I'm looking to use the rl23 in my 7mm mag. But i can't find any data hardly.

Sent from my SM-G935V using Tapatalk

 

[lungpuncher1]

All the info i can find other than a few forum posts. Anyone able to run this on quick loads? Im going to use a 160 accubond.

Sent from my SM-G935V using Tapatalk

 

[jlanecr500]

All the info i can find other than a few forum posts. Anyone able to run this on quick loads? Im going to use a 160 accubond.

Sent from my SM-G935V using Tapatalk

Don't have my laptop with me right now but I can run it in the morning. Will need to know what your COAL (cartridge overall length) is.

 

[lungpuncher1]

Awesome.

3.255"

Thanks!

Sent from my SM-G935V using Tapatalk

 

[MUP]

I've only read that it's supposed to be less temp sensitive, but very similar to R22.

 

[jlanecr500]

Quickload is only a guesstimate. Actual chamber pressure can vary due to throat, powder, etc variations

 

[lungpuncher1]

Quickload is only a guesstimate. Actual chamber pressure can vary due to throat, powder, etc variations

Thank you sir. Very helpful

Sent from my SM-G935V using Tapatalk

 

[markwondi]

I have played with RL23 in a few cartridges and found it to be slightly faster burn rate than RL22, but quite temp stable.

 

[lungpuncher1]

I have played with RL23 in a few cartridges and found it to be slightly faster burn rate than RL22, but quite temp stable.

Would you pick it over rl25 for a 7mm mag?

Sent from my SM-G935V using Tapatalk

 

[markwondi]

I have played with RL23 in a few cartridges and found it to be slightly faster burn rate than RL22, but quite temp stable.

Would you pick it over rl25 for a 7mm mag?

Sent from my SM-G935V using Tapatalk

Yes, absolutely. H1000 would be my first choice but RL23 and even RL26 will work well also.