The tilt and trim motor on my 1990 aluminum fishing rig with a 60 mariner died this morning. :bash: I have gone through the circuit and it am getting power to the motor, just seems to have died. Any ideas, would like to rebuild myself if possible, if not any recommendations where to get one here In the nashville area.
Tilt and trim
- Thread starter MMHunter
- Start date
JimFromTN
Well-Known Member
I don't know if they are still there but there was a place in Hendersonville off of new shackle island rd that would rebuild them. You best bet is probably ebay.
SilverFox
Well-Known Member
The switches die more often... make sure its not a switch first. If you have more than one like on the front, check it too.
You can probably get the motor rebuilt for a reasonable price. Not sure about the new models but most of the older models used a starter motor to run a small hydraulic pump. Got mine fixed at a starter/alternator rebuild shop for $40.
SES
Well-Known Member
Mine did the same two years ago and it was the relays.
