Ok so I thought I would make my loading easier by getting the t-handle traditions sells as well as the Barnes aligner tool. However, I imagined being able to leave the t-handle attached to the ramrod in the "ready" position. Just pull it out and push a bullet home. However, the threads do not fit into the end of the ramrod that is on the muzzle end. It only fits on the end that goes into the gun which means it can't be in the ready position. Is there a fix for this? Really aggravating with so many of these companies going to these ramrods you have to reverse the piece on to use. My Knight was full length and not that way, it had threads that could be used on both ends. Thanks
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
