Looking for an AR part

[TheAirMan]

That I am starting to think doesn't exist. I have a palmetto state lower. I am wanting to put an end plate on it with ambidextrous hookups for a single point sling. They are seemingly everywhere and I thought I had one that would work already. However, the one I have and everyone i can find, has an oval protrusion that goes into the lower and my lower has a round hole not oval. Does anyone know if one with a round protrusion exists and if so where bouts you can find one?

 

[hillbillyfab]

Can you post a picture? Is it something similar to this?
https://botach.com/blackhawk-70sm04bk-u ... ng-mounts/

 

[TheAirMan]

Something like this is what i have and am wanting. However, that little oval part sticking up would have to be round.
https://www.midwayusa.com/product/1019064949

 

[infoman jr.]

Have you tried the oval one in your receiver? I'm not aware of a lower with an oval hole in the rear, and I'm pretty sure an end plate with oval protrusion would work.

 

[TheAirMan]

Have you tried the oval one in your receiver? I'm not aware of a lower with an oval hole in the rear, and I'm pretty sure an end plate with oval protrusion would work.

I did and it didn't want go go. After reading your comment I tried again. I had to get a fair amount meaner than I thought I should have but it went. I'm not sure the little piece that sticks up is up far enough to do anything though.

 

[ROVERBOY]

if you had to, could you stone or use a needle file to shape it to work? If I did this, I would go slow, and check a few times for fit.

 

[TheAirMan]

I've got it put together now. There must have been a burr or something somewhere because after I took it back out it goes back in easier. I mean it didnt fall in but was a fair amount easier.

 

[Pennywise67]

look for one with a QD swivel mount end plate. I know Primary Weapons systems makes one,

-Larry