load question....

Tennessee Deer Sporting & Deer Hunting Community Forum

Help Support TNDeer | Tennessee Deer:

.444 Marlin

Well-Known Member
Joined
Aug 10, 2002
Messages
15,499
City & State/Province
Benton, Polk Co. Tenn.
Ok I finally got some range time in with the .223
The loads I took are..
50gr NBT over 26.0 Varget w/ CCI-400 small rifle 3220fps +/- @ %95 and no pressure problems at all. Shot great. Definatly keeping this load.

60gr V-Max over 25.0 H335 w/ CCI-400 small rifle 3102fps +/- @ %92 no pressure problems and shot great.

But, the 60gr hornady SP's loaded exactly the same as the v-max had problems. Blew one primer out and bulged the center of 2 others. Didn't finish the last 7 rounds but it did shoot good. Not keeping this one.

My question is, why would just the sp loaded the same as the v-max act as if they were loaded so much hotter than the v-max??
 
Yeah it did good on its first outing even tho it was 3/4" groups at 50yr but this was just to get it sighted in good enough for coyotes out to about 200yd. Ill fine tune it when it ain't 98,000* out.
 
The SP is a little less streamlined bullet and at the same overall cartridge length you may be getting into the lands a bit perhaps a bit more with the SP than the V-Max. Hornady shows the same reloading data for both rounds but I notice that they do show the SP loaded to a overall length .050 shorter than the V-Max in their data. Maybe that's it?
 
Whelen Man said:
The SP is a little less streamlined bullet and at the same overall cartridge length you may be getting into the lands a bit perhaps a bit more with the SP than the V-Max. Hornady shows the same reloading data for both rounds but I notice that they do show the SP loaded to a overall length .050 shorter than the V-Max in their data. Maybe that's it?

Hmm...interesting. I think imma pull the bullets and load them the same as they were but at a max OAL of 3.000" and see where it goes.
 

Latest posts

Back
Top