Forums
New posts
Search forums
What's new
New posts
New Trophy's
New trophy room comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Classifieds
Trophy Room
New items
New comments
Latest content
Latest updates
Latest reviews
Author list
Series list
Search showcase
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Tennessee Fishing Forums
Fishing Forums
Jon boat project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="catman529" data-source="post: 2736064" data-attributes="member: 9284"><p>Yeah a google search does not show much about E6000 but I did not see any negative reviews at all. One guy said it ripped up a 0.040 aluminum panel when trying remove a glued-on trolling motor mount. There is some clear epoxy-like glue on some of the rivets on the inside of my boat, my guess is it's either epoxy or E6000, seems to be slightly flexible. Either way I hope it works well. It's supposed to be fairly tacky, but as it sets, it will run a little so I hope it will fill in all the cracks for a good solid seal, not looking for a paste anymore to cover the rivets with, found it's not a good idea. Some of the JB weld has already cracked and I could chip it off with a chisel while chipping off the black stuff. I sanded the areas but did not clean them properly so adhesion was bad. Even if adhesion was good, JB weld cracks too easily. Lesson learned, hope this new stuff works.</p></blockquote><p></p>
[QUOTE="catman529, post: 2736064, member: 9284"] Yeah a google search does not show much about E6000 but I did not see any negative reviews at all. One guy said it ripped up a 0.040 aluminum panel when trying remove a glued-on trolling motor mount. There is some clear epoxy-like glue on some of the rivets on the inside of my boat, my guess is it's either epoxy or E6000, seems to be slightly flexible. Either way I hope it works well. It's supposed to be fairly tacky, but as it sets, it will run a little so I hope it will fill in all the cracks for a good solid seal, not looking for a paste anymore to cover the rivets with, found it's not a good idea. Some of the JB weld has already cracked and I could chip it off with a chisel while chipping off the black stuff. I sanded the areas but did not clean them properly so adhesion was bad. Even if adhesion was good, JB weld cracks too easily. Lesson learned, hope this new stuff works. [/QUOTE]
Verification
Post reply
Forums
Tennessee Fishing Forums
Fishing Forums
Jon boat project
Top