I haven't run either of these in probably 6-7 years or more; no need between my MS-362 and MS-180.
The Stihl MS-440 Magnum was rebuilt by Randy Evans aka Mastermind of TheArboristSite and Outdoor Power Equipment fame around March 2014. https://mastermindsaws.com/ If you're a member of either site, you're familiar with Randy's work and reputation. Once I got it back from Randy, I used it with a 20" bar (not included) for less than an hour, then let it sit since and replaced it with my -362 (-362 is lighter).
The 440 is a pro-level 70 cc saw (more hp/lb, larger gas and oil tank, better vibration isolation, metal crankcase etc.). Randy rebuilt the upper and ported it and opened up the exhaust (hearing protection required!). Power head only. Hasn't run since 2014 after it was rebuilt; will need to be carb cleaned and probably a new spark plug. It also has some plastic impact damage, pics below shows this. Otherwise, it should be good to go. $375 FTF near Ardmore TN. See pics below.
The Husky 350 is a 50 cc saw with an 18" bar and chain. Hasn't run since 2015 or so. Will probably require some loving to get running.$75 $50 FTF near Ardmore TN. See pics below.
The 440 is a pro-level 70 cc saw (more hp/lb, larger gas and oil tank, better vibration isolation, metal crankcase etc.). Randy rebuilt the upper and ported it and opened up the exhaust (hearing protection required!). Power head only. Hasn't run since 2014 after it was rebuilt; will need to be carb cleaned and probably a new spark plug. It also has some plastic impact damage, pics below shows this. Otherwise, it should be good to go. $375 FTF near Ardmore TN. See pics below.
The Husky 350 is a 50 cc saw with an 18" bar and chain. Hasn't run since 2015 or so. Will probably require some loving to get running.
Last edited: