• Help Support TNDeer:

Looking to change up bullets

Can't go wrong with anything made by Barnes. Hornady shot good for me, but just liked the barnes better when I had my 45 Encore. I do have a bullet I recovered and will post a pic later after I get a chance to take a pic of it.
1666448920377.jpeg
 
Well the bore drivers seem pretty accurate. I grouped just under an inch at 100 with 75 weighed out of a Huntsman. My buddy put them through the same hole with a CVA. Now to see how they do on a deer.
 
Where do you get these MUP?
Muzzleloaders.com It's Knight Muzzleloaders website. Comes in a pack of 20, with sabots, for 8 or 9 bucks I think. I just ordered 4 more packs as I found I was low over the weekend of shooting. ;)

I also designed and made a bullet mold from this design as well. I just need more lead to make an adequate run of them. I did cast some a few years ago, and killed a nice 7 pt with them, but the tin level was too high I believe, causing the bullet to shatter instead of penetrate and mushroom. Pure lead would likely do much better.
 

Latest posts

Back
Top