I went back to the range today to shoot my ML a little more and to get some confidence at 150yds with it..At 100 yds,my CVA will group the 350gr FPB in about 1.5inches of each other, that is starting with a clean bore,the first shot with the clean barrel is always just a tad different,by about 1 inch from the following 2 shots..The After fowling the barrel with the first shot,it will group the following 2 shots touching each other,but all 3 shots are within 1.5 inches of each other..
Shot that 3 shot group at 100yds,and then cleaned the barrel,and back the target up to 150,First shot with a clean barrel,was about 14 inches low!!I thought that maybe I jerked it,so I fired another shot,and it was about 5 inches low,fired a third shot and it was again about 5 inches low, and was right there with the 2nd shot..I cleaned the barrel again and repeated,and got the same results..With a clean barrel,it shoots about 12 to 14 inches low at 150yds,but after you fowl the barrel,it only shoots about 5 to 6 inches low..I did this three times,and got the same results all 3 times..It does group them well at 150,but I just never did measure,I figured if I could keep them all on the shoot-n-see target at 150,then that was minuete of deer accuracy enough at that distance..It doesnt shoot to the left or right,just always low.It doesn't do it at 100yds,if it does,its very very litte,not enough to tell..Hard to think just 50 yds would cause it to do that..Im super confident at 100yds with it from the groups it puts out,and at 150yds,i'll just aim about 6 inches over the deers back,if I have to,gonna try to stay away from those longer shots..If it wasn't so close to season i'd try to up the charge to 150grs and see what it does..
After ML season,im gonna switch from pellets to loose powder and try the hornady FPB 300gr bullets..So I can tweek the powder 5grains here and there and shrink the groups even smaller..
Shot that 3 shot group at 100yds,and then cleaned the barrel,and back the target up to 150,First shot with a clean barrel,was about 14 inches low!!I thought that maybe I jerked it,so I fired another shot,and it was about 5 inches low,fired a third shot and it was again about 5 inches low, and was right there with the 2nd shot..I cleaned the barrel again and repeated,and got the same results..With a clean barrel,it shoots about 12 to 14 inches low at 150yds,but after you fowl the barrel,it only shoots about 5 to 6 inches low..I did this three times,and got the same results all 3 times..It does group them well at 150,but I just never did measure,I figured if I could keep them all on the shoot-n-see target at 150,then that was minuete of deer accuracy enough at that distance..It doesnt shoot to the left or right,just always low.It doesn't do it at 100yds,if it does,its very very litte,not enough to tell..Hard to think just 50 yds would cause it to do that..Im super confident at 100yds with it from the groups it puts out,and at 150yds,i'll just aim about 6 inches over the deers back,if I have to,gonna try to stay away from those longer shots..If it wasn't so close to season i'd try to up the charge to 150grs and see what it does..
After ML season,im gonna switch from pellets to loose powder and try the hornady FPB 300gr bullets..So I can tweek the powder 5grains here and there and shrink the groups even smaller..