Tndeer Logo

Page 1 of 3 123>
Topic Options
#3036702 - 11/16/12 04:51 PM How tight of groups are acceptable?
DMAG
4 Point


Registered: 11/13/10
Posts: 335
Loc: Bradley County, TN

Offline
I bought an old 1967 Remington 700 blued stainless 7 Mag several months ago that had a cracked stock. I put a zeiss scope on it and ordered a Boyds stock. I zeroed it today and shot 2 inch groups at 100 yards. We put about 20 rounds through it, not back to back, but couldnt tighten it up any more than that. The gun has had some work done to it. The barrel is cut down to 20 inches and has a muzzle break cut in the end. I was shooting Remington 150 grain core lokts and this was the best we could do.We dont have a lead sled, we were using towels to prop, but I felt fine shooting it. How tight are your acceptable groups?
Top
#3036706 - 11/16/12 04:57 PM Re: How tight of groups are acceptable? [Re: DMAG]
cecil30-30
16 Point


Registered: 12/05/06
Posts: 14345
Loc: Morgan Co

Offline
Have you tried different ammo? Was all 20rnds the same ammo?
_________________________
The beauty of the second amendment is that it will not be needed until they try to take it." -Thomas Jefferson


Ban Liberals!!! Save America!!!!

Top
#3036708 - 11/16/12 04:58 PM Re: How tight of groups are acceptable? [Re: DMAG]
Rockhound
10 Point


Registered: 04/04/11
Posts: 3091
Loc: Lawrence Co. TN

Offline
With work like that and factory ammo id be satisfied no telling what the round count is on that rifle being that old also
_________________________
Isaiah 40:31.... Those who wait upon The Lord .....shall renew there strength ......

Top
#3036745 - 11/16/12 05:21 PM Re: How tight of groups are acceptable? [Re: Rockhound]
KPH
10 Point


Registered: 08/06/05
Posts: 4032
Loc: Hendersonville Tenn

Offline
Two in. is not bad for a deer gun
_________________________
"No I am not a good shot, but I shoot often" Teddy Roosevelt

Top
#3036749 - 11/16/12 05:26 PM Re: How tight of groups are acceptable? [Re: KPH]
JimFromTN
8 Point


Registered: 07/14/08
Posts: 1469
Loc: Nashville, TN

Offline
2 inches at 100 yds is definately acceptable for hunting. I don't know that I would take much more than a 200 yd shot with it at game. If the barrel really is 20 inches, its much too short. 7mm mag is truly one of those rounds where you need at least a 24 inch barrel.
Top
#3036778 - 11/16/12 05:52 PM Re: How tight of groups are acceptable? [Re: JimFromTN]
BigD_625
10 Point


Registered: 09/30/09
Posts: 3395
Loc: Maury County, TN

Offline
I would shoot from a vise or sandbags to see what that does.
_________________________
-----------
It's better to be smarter than you look...than to look smarter than you are.

Top
#3036795 - 11/16/12 06:02 PM Re: How tight of groups are acceptable? [Re: BigD_625]
Model70Man
12 Point


Registered: 09/30/05
Posts: 6877
Loc: Knoxville, TN

Offline
I would have a gunsmith look at the gun. The muzzle could be damaged or out of round if it was cut down.

Also, cor lokt bullets aren't the most accurate bullets around. Try some ballistic tip or Accubonds bullets. In my experience, those bullets have been much more accurate.
_________________________
Winchester Model 70 Stainless Left Hand .270 Win.
McMillan Edge
Talley Lightweights
Zeiss Victory Varipoint #60 Illuminated

Top
#3036806 - 11/16/12 06:11 PM Re: How tight of groups are acceptable? [Re: Model70Man]
Chaneylake
Brownsville Mafia
16 Point


Registered: 12/18/07
Posts: 16792
Loc: on the wings of a snow white d...

Offline
more trigger time will probably cure the issue, I have put 2800 rounds through my .40-65 this year
_________________________
"Don't piss down my back and tell me its rain", Fletcher, Outlaw Josey Wales

Living somewhere between this world and the other, Legends of the Fall

Top
#3036862 - 11/16/12 06:52 PM Re: How tight of groups are acceptable? [Re: Chaneylake]
mr.big
Non-Typical


Registered: 01/03/01
Posts: 28915
Loc: Copper Head Road

Offline
I would be a nervous wreck with a rifle that shot two inches at 100 yards,,it is good enough to hunt with but it would get in my head,
_________________________
gun junky

Top
#3036865 - 11/16/12 06:54 PM Re: How tight of groups are acceptable? [Re: Chaneylake]
Buccaneer
6 Point


Registered: 08/29/06
Posts: 536
Loc: Hendersonville

Offline
My Savage 7mm Mag will cloverleaf 3 rounds at 100. 1/2" groups off Caldwell bags. Likely with the cut down barrel you should have it looked at by a gunsmith. Also what does the bore look like? Maybe an hour or 2 with JB Bore Paste would make a world of difference.
Top
Page 1 of 3 123>


Moderator:  RUGER, Bobby G, Unicam, CBU93, stretch, TurkeyBurd, Kimber45, Mrs.Unicam, Crappie Luck, gtk 
Hop to:
Top Posters
4106599
RUGER
88400
Deer Assassin
65979
BSK
62020
Crappie Luck
51392
spitndrum
Newest Members
yarddawg54, schiesser, bigdoc, Bggamehunter, willy2763
13605 Registered Users
Who's Online
3 registered (FrontierGander, gtk, Cowman71) and 78 anonymous users online.
Forum Stats
13605 Members
43 Forums
100233 Topics
1180122 Posts

Max Online: 788 @ 11/11/13 08:06 PM
Moon Phase
CURRENT MOON
December
Su M Tu W Th F Sa
1 2 3 4 5 6
7 8 9 10 11 12 13
14 15 16 17 18 19 20
21 22 23 24 25 26 27
28 29 30 31
Forum Donations
The TnDeer.Com Deer Talk Forum is for Tennessee Deer Hunters by Tennessee Deer Hunters. If you enjoy using our Talk Forum and would like to contribute to help in it's up-keep. Just submit your contribution by clicking on the DONATE button below and paying with PayPal or a major credit card. Any amount is much appreciated. Thanks for your support!

TN Burn Safe

Generated in 0.007 seconds in which 0.002 seconds were spent on a total of 15 queries. Zlib compression enabled.