Tndeer Logo

Page 1 of 2 12>
Topic Options
#1218685 - 03/05/09 05:23 PM Beard Displays?
Gray Ghost
TnDeer Old Timer
14 Point

Registered: 01/10/00
Posts: 7877
Loc: East TN, USA

Anybody got any creative ideas on cool ways to display multiple beards? I've got 10 or 15 birds I'd like to honor. Thanks in advance!
Witness to the Execution

#1218693 - 03/05/09 05:28 PM Re: Beard Displays? [Re: Gray Ghost]
Woodpile Boys
12 Point

Registered: 08/31/05
Posts: 6389
Loc: the hill

I took a piece of barn wood and made one about to leave the house but i will post ya some pics tonight also has some cool ones.
"Dont talk about it be about it"(Turkeyburd)

#1218822 - 03/05/09 06:37 PM Re: Beard Displays? [Re: THE ONE]
Woodpile Boys
8 Point

Registered: 02/25/09
Posts: 1486
Loc: Chapel Hill

Take a hull and cut the brass off. Use a screw driver to knock the primer out. Take a piece of wire wrap it around the beard makin a loop you can run through the hole in the brass. You can hang it however you want. I can probably post a pic tomorrow
Don't know, don't count the beers I drink anymore either. -Poor redneck

#1219149 - 03/05/09 08:46 PM Re: Beard Displays? [Re: WingNut]
10 Point

Registered: 08/01/02
Posts: 4083
Loc: Tennessee

you'll need:
hot glue
12 gauge shot shell
about a 15 inch lanyard (a boot lace will do fine)
a half inch long piece of paper clip
1 bearded turkey with spurs

Cut off beard.
Cut off spurs with hacksaw about 5/8 inch above and below spurs.
Cut off brass end of shot shell
Boil spurs until meat begins to peal
heat up glue

Take spurs from water, let cool
Use an un-cooked spagheti noodle to push tissue out of inside of spur. Cut away flesh from leg bone of spur being careful not to cut away black, hard part of spur. This should leave a clean spur.

put lanyard through hole in leg bone of both spurs
place the lanyard ends through the flat side (primer side) of the brass and pull bothe ends through the primer hole.

hold both lanyard ends together and about 1/4 inch from the ends push the half inch paper clip (or any wire/pin) through
This is simply done so the lanyard does not pull bach through the brass primer hole.

Pull the pin back into the open brass until the pinned together ends are recessed back up into the brass. You'll need room for the beard.

Melt some hot glue into the brass about half full and push the nub end of the beard into the open end of the brass up next to the pinned lanyard.

Now you have a hanging beard and spurs in a shot shell.

I hang mine in my trophy room. The hot glue holds the beard together for years.


Edited by 102 (03/05/09 08:53 PM)
God, Family, Job, Bowhunting
Luck is where Opportunity and Preparation MEET!
When in doubt...back out!
SCAPAS.stay calm and pick a spot.

#1219197 - 03/05/09 08:59 PM Re: Beard Displays? [Re: 102]
Outdoor Lady
16 Point

Registered: 11/21/06
Posts: 14497
Loc: Maynardville, Tn

Will you post a pic, please.
A Well Behaved Woman Rarely Makes History

"Outdoor Lady"

#1219266 - 03/05/09 09:21 PM Re: Beard Displays? [Re: Outdoor Lady]
14 Point

Registered: 08/27/03
Posts: 9038
Loc: Oliver Springs, TN

Offline please!!!!!
WARNING I'm Baaaaaack!

#1219426 - 03/05/09 10:19 PM Re: Beard Displays? [Re: spctbone]
8 Point

Registered: 10/16/08
Posts: 1956

im redoing some of mine like 102 except i use epoxy. im also going to make a picture frame with a shelf for the bottom of the frame. ill put some brass hooks at the bottom of this for all my 10" and above beards. the picture frame will have an original piece ive been working on for some time, a charcoal and pencil grey scale pic of a lone gobbler in the woods. and the shelf portion of the frame im going to place one of my scrimshawed wingbone calls.

if you dont want the spurs attached like that you could just hang the beards. get a small decorative shelf and drill holes through it big enough so that the shotgun brass will fit thru to hang. then you could use the shelf to show off an old call or an 8x10 of the hunt. i think they may sell these commercially too.

#1219649 - 03/05/09 11:43 PM Re: Beard Displays? [Re: WTM]
10 Point

Registered: 08/15/07
Posts: 4102
Loc: Hardin, Co.

Here's a picture of mine.

" Some localities are willing to work for their sport, and have plenty. Others are willing merely to take what comes easy, and have little or none." - Aldo Leopold

#1219669 - 03/06/09 12:59 AM Re: Beard Displays? [Re: 8 POINTS OR BETTER]
12 Point

Registered: 06/03/04
Posts: 5133
Loc: Southern Wayne CO and NW Alaba...

I've got some new ideas but I just haven't got around to them yet.
I've posted these before I'm sure but here goes again (sorry, I know not all are just "beard" displays:

My two best Easterns. One on top is a TN bird. 11 3/4" beard with 1" spurs. Bottom is my best overall Eastern Weighed 23lbs, 10 5/8" beard but was as round as a 20oz coke bottle when I shot him and had almost a 1.5" spur. Other was broke. He was shot at Skyline WMA in Alabama about 1 mile from the TN line at Bear Hollow MT.

Here's a few more:

I think I'm going to make some necklaces with some spurs and small spike sheds I have. I'll get bored one day and get around to it. lol

Edited by AlabamaSwamper (03/06/09 01:01 AM)
Official BTR Scorer in NW Alabama and southern middle Tennessee

#1219704 - 03/06/09 05:15 AM Re: Beard Displays? [Re: AlabamaSwamper]
4 Point

Registered: 03/05/09
Posts: 116
Loc: TN

Dang 8points you got 31 beards there.
Page 1 of 2 12>

Moderator:  RUGER, Bobby G, Unicam, Cuttin Caller, CBU93, stretch, TurkeyBurd, Kimber45, Mrs.Unicam, Crappie Luck, Grizzly Johnson, gtk 
Hop to:
Top Posters
Deer Assassin
Crappie Luck
Newest Members
yarddawg54, schiesser, bigdoc, Bggamehunter, willy2763
13605 Registered Users
Who's Online
0 registered and 17 anonymous users online.
Forum Stats
13605 Members
43 Forums
100243 Topics
1180151 Posts

Max Online: 788 @ 11/11/13 08:06 PM
Moon Phase
Su M Tu W Th F Sa
1 2 3 4
5 6 7 8 9 10 11
12 13 14 15 16 17 18
19 20 21 22 23 24 25
26 27 28
Forum Donations
The TnDeer.Com Deer Talk Forum is for Tennessee Deer Hunters by Tennessee Deer Hunters. If you enjoy using our Talk Forum and would like to contribute to help in it's up-keep. Just submit your contribution by clicking on the DONATE button below and paying with PayPal or a major credit card. Any amount is much appreciated. Thanks for your support!

TN Burn Safe

Generated in 0.011 seconds in which 0.005 seconds were spent on a total of 15 queries. Zlib compression enabled.